Have you ever wondered how to silence your paintball gun? maybe a Spyder or Tippmann, well I wanted a cool sniper gun, and figured a pump Traccer was just the marker to do it with.

free homemade silencers suppressor


By Joan Hallmark - nikki castouras crash photos | on the border resturants

Posted by Dana Hughey ourei harada videos | hobet sample questions

I started with a 25 micron water sediment cartridge I bought at Sears. I think it was a little overpriced at about $12 but whatever. Essentially it's a foam wound tube that goes into a whole home water system. Next a trip to Home Depot. I bought a 12' piece of CPVC " inch tube from the plumbing section $10 I cut it up into 3 pieces to get it home. You will also need to pick up 2 of the " connectors in the same section. The connectors inside diameter are already the size of the stock Trracer barrel 1" outside, and the " inch tube is big enough to let the paintball slide through.

The outside diameter of the connector is the same size to as the inside of the water cartridge, making a really nice tight fit. So next cut the tube to the length of the water filter. The connectors are going to go into each end of the water filter to keep it straight and solid inside. Then I bought two types of Camo tape from WALMART hunting section. One was the removable tape, $6, the other was Camo duct tape (way bigger roll for $8.

contoh sulaman labuci 


  • Top 5 News Storiesmiley cyrus phone number and address

  • radio controled helicopter

    fisher snow plows

    I started with the Duct tape wrapping the front, then the outside of the tube, make sure to overlap to not leave any gaps.
    We want it to be basically air tight. The other end of the tube gets the removable tape, which allows air through. Once done the tube will be fully covered in camo tape, The front will be covered in Duct tape, the back in the non shiny removable tape.
    alamo drafthouse westlakes
    I used the two different kinds of tape, because we don't want to build a silencer that's just huge, so we need somewhere for the extra gas to go, so it doesn't pop a hole in the tape.
    clayton county georgia detention center
  • room assignments nursing boardexams december 2007

    ashley leggat nudes

    The back removable tape lets the gas and noise out, but back towards you, not towards your victim.
    Next use a dremel to cut holes and slots in the tube, and smooth the inside front and back of the tube, if you look into the tube with the connectors in you can see the lip of the tube, smooth that away.
    I added the foam around the tube so the gas doesn't blow around the ball and come out in front of the paintball. So now smooth the outside and inside.
  • street gossip mixtape track listings

    room assignments nursing boardexams december 2007

    For the inside I used a wood dowel with very fine sand paper taped on the end for the inside of the tube, it seemed to work ok.
    Once all the little pieces were gone, I hot glued the foam strips on and the BACK connector together.
    The front connector I glued to the inside of the water cartridge, so it's still possible to take it apart if really needed.

     free ambigram designs

    the marriage of figaro k 492

    chicas manando verga

    A look from the front down the barrel, notice the holes in the tube.
    Here it is with the silencer on. There is a noticeable change in the noise, even dry firing, the high crack of the shot is now gone, the low pop is still there.
    With a paintball it's even quieter! Now total cost of the project Water filter $12 CPVC tube $10 Connectors $1.
  • tonya cooley cinemax freeones

    shorty layered bob hairstyles

    50 Camo Duct Tape $8 Removable camo tape $6 Foam and glue, I had already.
    Total $37. 50 but, I do have tons of Camo Duct tape, and CPVC tubing left. Easily enough for 4 more silencers. The removable stuff would do for 4 more as well.
    So if 5 people together and made them it would be just $18. 60 each. Now a word of warning. I am not in the US, according to the ATF this is illegal, even though it is for your paintball gun, not a real gun.